Floor Plates, Top Column Hole, Brake & Clutch Punch Out, 2 Piece

Part Number: 4669-5356T Original Part Number: B3C-811215011-T

These plates replace all our other TOP COLUMN HOLE designs.  They have punch-outs for the brake or clutch so can be used with Auto, Manual or even swing pedals.

Plates are used as a sandwich with the rubber insulator between two pair, both are then installed on the inside of cab floor.  

Just an observation, we find in most cases: 

            Mustang II
conversions…Uses TOP Column position.

            GM, Toyota,
400, Volari…Uses MIDDLE Column position

            Stock Column…Uses
STOCK or Lower position

We have attempted to cover most
applications with the 3 positions, however your individual preferences on the
location of your column may require some trimming.  Note our full plate rubber insulator will accommodate
and seal out air and dust in any location.

Plates are installed as a “sandwich”
with two plates on top, rubber insulator in center, and two plates on bottom.  The entire assembly is then mounted to the
floor.

See the complete kits of all
pieces at a savings:

94668-5356…Stock Column Location,
 

94669-5356M...Mid Column Location, 

94669-5356T…Top Column Location.